1961 Volvo P1800 project, part 17

If this is part 17 of this Vintage Volvo Tale..I wonder how many parts it will take before this car is back on the road?? 300??…500??  957?? Damn if I know…Oh well, we will keep keeping on!

1961 Volvo Jensen P1800 rust free

Dippety-Doodaa !!!

1961 Volvo Jensen P1800 inner fender well

Wow…It is like is was 1960 again and the car was just made at Pressed Steel!

1961 Volvo Jensen P1800 clean metal

 

The rear of the car is very clean and solid.

I did say rust free earlier and that is technically true but we certainly have some perforation caused by rust. I also found some lousy repairs on both the doors and the quarter panels. I plan to replace all of them, no need to be cutting any corners at this point. I have to order panels now, more on this later.

 

In the mean time, I keep fiddling with the small stuff:

1961 Volvo Jensen P1800 early idler arm

Only the early cars had this idler arm. It actually used needle bearings as opposed to the later models that use a bushing. To me this will help steering effort to a small degree.  As you can see on the old shaft, the most wear and stress happens on the top. The kit includes the shaft so all good.This was the last rebuild kit available so me happy!

 

1961 Volvo Jensen P1800 new parts

This is what $1200.00 worth of new Volvo parts looks like. This is the third of many “installments”. I think I need a separate shelf for all this to keep order and more important…my sanity!

 

1961 Volvo Jensen P1800 exhaust manifold studs

Hot Action shot! The heat is on.

The exhaust manifold studs were in rough condition so they had to be replaced. After 50 years of marriage to the manifold flange they were not about to divorce easily.

However, after introducing the flange to an Oxyacetylene Torch at about 1980 C and thus making the molecules really excited (and red) the studs reluctantly departed.

1961 Volvo Jensen P1800 rear brake drum cleanup

Before and…you guessed it, skipper…after shot of the break drums after a couple of days soaking in the rust removal solution. They will be powder coated with high temp coating.

 

1961 Volvo Jensen P1800 new caliper

I was able to secure one left side early caliper from VP-Autoparts and that was it. I checked with a local rebuilder and I was quoted over $300.00 per ea caliper!

1961 Volvo Jensen P1800 caliper pistons

My friend Gary Ramstad, president of the local Volvo club was generous and gave me these caliper rebuild parts. All that is missing is the large piston and I can get those from VP for 20 bucks.  As long as I can get the pistons out I should be able to rebuild them. The calipers are soaking right now, more later.

 

1961 Volvo Jensen P1800 springs

It is a pleasure to see that many new parts are actually made in Sweden. The new springs are made by Lesjöfors in Sweden.

 

1961 Volvo Jensen P1800 trans cross member

This is the transmission cross member. See that bend on the left side? I was certain that the previous owner took this fine car for a spin in some rough terrain. I checked under my 1964 parts car and it has the same recess, however it is factory pressed. What is going on here??

Turns out it is a recess to clear the speedometer cable. Jensen factory workers just took the stock Volvo cross-member, grabbed a sledge-hammer and beat it in submission. Chalk that up to another “early car quirk”

1961 Volvo Jensen P1800 modified cross member

There is even a mark when they missed a little or got a bit generous with the sledge-hammer. Totally cool !

 

 

Volvo P1800 logga