1961 Volvo P1800 project, part 20

1961-volvo-jensen-p1800-body

Now I have done it!! There is no way back now.

1961-volvo-jensen-p1800-fender-off

In order to get to the rocker assembly the fender have to be removed. This right side fender will be replaced with a new fender. The driver’s side fender appears to be in much better condition, I am not sure if I need to replace it.

1961-volvo-jensen-p1800-quarter-panel-removing

This is the edge left from quarter panel. After cleaning up the spot weld remnants I have a nice surface to attach the new panel.

1961-volvo-jensen-p1800-weak-rocker-panel

This is why it is usually not enough to replace just the outer rocker panel. If the rocker panel is weak chances are that the sub rocker below have issues as well. …and it does!

1961-volvo-jensen-p1800-rusty-rocker-sub-support

And…if the sub rocker have issues there is a good chance the sub rocker support panel also have issues…and it DOES! This panel goes all the way back to the rear wheel well.

1961-volvo-jensen-p1800-rocker-parts

Bottom line, once I am in this far, there is no excuse for not replacing all components. Fun fact: the original rocker assembly from Volvo came as one unit. The aftermarket parts come in three sections. This makes it easier to bang them around to fit the body.

1961-volvo-jensen-p1800-rocker-removal

I HEART my plasma cutter. I obviously need to drill out all the sport welds that holds the rockers in place but it is easier if I remove most of the rocker first. By doing this it is easier the see how it is attached, what metal overlaps what etc…Instead of using a cut off wheel and filling the shop with metal dust I fired up the ‘ol plasma cutter. It is fast and much less messy compared to the cut off wheel.

1961-volvo-jensen-p1800-rocker-gone

With the rocker and sub rocker gone we can now see the inner rocker support structure.

1961-volvo-jensen-p1800-crud-in-rocker

This is part of the crud I found inside the rocker panel. I did not have a banana handy so…glove for scale.

1961-volvo-jensen-p1800-spot-weld-removal

Since the front fender is being replaced, I cut the fender off about an inch from the edge so I can see what was going on below.

The Spitzernagel Special is an amazing tool for removing the spot welds.  Also, because of the clamp that holds it in place, there is no effort. It only removes the spot weld but stops short of digging in to the bottom layer.

1961-volvo-jensen-p1800-fender-support

This is what the fender support looks like under the fender. It even has little indentation to ensure dirt and moisture will lay around and eating your Swedish sports car from the day you leave the show room! Brilliant!

I guess these cars were supposed to last ten years at the most so these “engineering blunders” were probably not an issue at the time. I bet they did not expect car guys restoring these cars 56 years later. Luckily, this part of the car is very solid.

Mo later…